Furniture Kit for 2322 model kilns
This is high alumina kiln furniture rated to cone 11.
Two 21″ diameter half shelves.
Three 21″ diameter full shelves.
Three each 1″, 2″, 6″ and 8 posts.
Six each 4″ posts.
All posts are 1 3/4″ square.
Two kilograms kiln wash.
Kiln Wash is used to protect kiln shelves from glaze drips and pottery from sticking to the shelves.
It comes as a powder which you mix with water to a milky consistancy.Apply it to the top side of kiln shelves with a brush.
It is better to apply several thin layers than one thick layer.
Please do not apply kiln wash to the bricks of your kiln.
If you require kiln wash for glass slumping please specify.
These kiln shelves are made from a refractory mix that is high in alumina.
They are rated for use up to cone 11 in oxidation or reduction atmospheres.
We suggest using three posts per shelf for optimum stability.
If we do not stock the size that you need please request a quotation.
We can cut shelves at a cost of $4.00 per cut.
Stock sizes are;
10″ x 1/2″ full round
13″ x 1/2″ full round
15 1/2″ x 5/8″ full round
15 1/2″ x 5/8 ” half round
21″ x 3/4″ full round
21″ x 3/4″ half round
26″ x 3/4″ full round
26 ” x 3/4″ half round
21″ x 10 1/2″ x 3/4 rectangle
26″ x 13″ X 3/4″ rectangle
These kiln posts are rated up to cone 11 in oxidation or reduction atmospheres.
We suggest using three posts per shelf for stability.
Always try to stack each layer of posts directly above each other so that the weight of all shelves rests on the kiln floor and not on the shelf below.
These posts are all 1 3/4″ X 1 3/4″ square and are available in the following sizes;