Cart

Best Selling

This terminal is part of the wiring harness in the control panel.

This is high alumina kiln furniture rated to cone 11.

Two 21″ diameter half shelves.

Two 21″ diameter full shelves.

Three each 1″, 2″, 4″, 6″ and 8 posts.

All posts are 1 3/4″ square.

Two kilograms kiln wash.

 

 

High alumina furniture which can be fired up to cone 11.

One 10″ dia. shelf

Three 1″ posts

One kg. kiln wash

Overview

  • 4.7 Cubic Feet
  • Double Wall Construction
  • Kanthal A-1 Elements
  • 208 or 240 Volts
  • 50 Amp Breaker Required
  • Bartlett Controller

The Orton Vent Master vents the fumes directly from the kiln before they exit the kiln into the room.

This is a very effective venting system which we highly recommend with every kiln.

All Vent masters include the main blower and motor ,one three foot high temperature hose,one fume collector cup,hose clamps,instructions and test firing cones.

The collector cup attaches to the side of the kiln.

The motor can be left on the floor or attached to the wall.

Overview

  • 1813G is – 1.98 Cubic ft
  • 208 or 240 Volts
  • 40 Amp breaker required
  • Kanthal A-1 elements in lid and walls.

Specify voltage when ordering.Relays are available in12 volt,208 volt or 240 volt.
The most common relay on a kiln with an electronic controller is the 12 volt version.Please check with our technical support to determine which relay you need.

This is high alumina kiln furniture rated to cone 11.

Two 21″ diameter half shelves.

Three 21″ diameter full shelves.

Three each 1″, 2″, 6″ and 8 posts.

Six each 4″ posts.

All posts are 1 3/4″ square.

Two kilograms kiln wash.

 

 

 

High alumina kiln furniture which can be fired up to cone 11.

Two 15.5″ dia. full shelves.

Three each 1″,2″4″,and 6″ posts.

Two kgs. kiln wash.